🔁

Installation Guide: Automated Cycle Count Add-On

You can install additional Amper hardware to get automatic cycle counts collected into the Amper system. If you want to learn more about this add-on, contact your Customer Success Manager.

NOTE: Please be sure to read all articles and watch any corresponding videos before starting the installation process.

  1. Familiarize Yourself With the Add-On Hardware & Overall Installation Process
  2. Connect Digital Aggregator to Base System
  3. Connect Digital Aggregator to Power & Signals
  4. Submit Install Form

🔊

A few things to note before you get started: Schedule Time to Turn Off Machines To install your Amper hardware, you'll need access to both the machine and the machine's power panel. It is recommended that you turn off the machine during install, so you can safely open up the panel. If you plan to do this, be sure to schedule time in advance to avoid any disturbance to machine operators Plan Installation Time with Maintenance Staff Since the installation will be done partially in the machine panel, it is essential to have a member of your team who in knowledgeable about the inside of a machine. In most facilities, this will be a member from your Maintenance or Engineering staff. Make sure to discuss availability with the proper team member to ensure they are available to assist.

Step 1: Familiarize Yourself With the Add-On Hardware & Overall Installation Process

🔄
Automated Cycle Count Overview
☑️
Pre-Install Checklist

Step 2: Connect Digital Aggregator to Base System

Adding the Digital Aggregator to the Base System

Step 3: Connect Digital Aggregator to Power & Signals

↕️
Selecting the Signal(s) to Monitor For Automated Counts
🔧
Connecting Signals to the Digital Aggregator for Automated Counts

Step 4: Submit Install Form

📄
Cycle Count Add-On Install Form